Unable to take off code 30064 is an error message that can occur when trying to launch a DJI drone.
The error is typically related to a software issue or a problem with the drone’s GPS system. There are a few possible causes for this error, including:
- Drone damage: If the drone has been damaged in a crash or has undergone physical trauma, it may not be able to take off. In such cases, it is recommended to contact DJI for support.
- GPS system problem: The error code 30064 can also be caused by a problem with the drone’s GPS system itself. Issues with GPS connectivity or accuracy can prevent the drone from taking off.
4 Ways to Fix DJI Drone’s Unable to Take-off
To fix the “Unable to take off (Code: 30064)” error, you can try the following solutions:
Refresh firmware
Try refreshing the firmware on both the drone and the controller using the DJI Assistant software. Updating the firmware can often resolve software-related issues.
Calibrate sensors
Use the DJI Assistant software to calibrate the drone’s sensors, including the compass and IMU (Inertial Measurement Unit). Sensor calibration helps ensure accurate readings and can potentially fix the issue.
Check GPS signal
Make sure that the drone has a strong GPS signal before attempting to take off. Flying in areas with poor GPS reception can result in errors and unstable flight.
Contact DJI support
If the issue persists, it is advisable to reach out to DJI’s customer support for further assistance. They can provide specific troubleshooting steps or guide you through the repair process if necessary.
Final Thoughts On DJI Drone’s Unable to Take-off
You drone is unable to take-off due to following reasons.
- Damaged drone or components.
- GPS system malfunction.
- Software issue.
- Firmware needs refreshing.
- Gimbal motor under excessive load.
